First, how is the excellent condition and service life of the tool inferred?
In the automatic machining process of the machine tool, it is required to use the ear to cut the sound, the cutting process is stopped, the test is stopped or the tip is touched, and the surface brightness is inferred according to the analysis of the surface brightness!
Second, why do you choose the correct tool according to the material characteristics?
In the process of processing, if the tool is not selected correctly, it will cause the processing to be unstable or impossible to process! And it will affect the efficiency and can not make good character. Therefore, it is very important to use the tool. When we process the material against the hard material, we should use the tool with a rigid and strong knife tip. The machine should also use low speed, slow feed, less back and other principles to debug! The processing material is soft, such as aluminum alloy, nylon rod, copper, etc.! Then we can increase the speed, feed rate, back the amount of knife, and use the corresponding alloy knife! Unique is the feed table Slow, it will cause slag, entangle the workpiece, and not slag. This will greatly affect efficiency and character!
Third, when the process or the tool path is not arranged to affect the efficiency, what if?
1. The same knife, although not repeated and repeated use, can not use a second knife to complete a knife, the order of the knife and the program in the case of the conditional promise, must be arranged according to the knife path, try to shrink the space Time, reduce the unnecessary positioning deviation, in the case of no impact on the tool or character, once again optimize the program and arrive at a good processing form!
Fourth, when it is easy to deform when processing thin products, what should I do?
Such a product is so difficult, and some may be divided into many processes to complete, may wish to analyze and infer according to product requirements! Must use low speed, slow feed, less back to eat three major processing factors! The tip of the knife is small, the blade is sharper than the sharp tool, and the clamping is also used as much as possible for the axial clamping (such as the pressure screw sleeve). If the radial home is tight, there will always be a deformation state!